• Mick A Martin's Avatar
    03-09-2018, 6:14 PM
    I have both the wired and Bluetooth Wincnc pendants ....... you need the serial keypad enabled if it's not then you need a new DAT file.
    6 replies | 229 view(s)
No More Results

3 Visitor Messages

  1. View Conversation
    The laser can cut on a vector the thickness of the line and a cnc cannot. The laser has the ability to produce very high detail shallow carvings and even photos and a cnc cannot. The laser cuts without cutters that need sharpening and does not change through use. I have both and that is why you need both.
  2. i have never seen the need for a laser in my world, so i do not have one
  3. View Conversation
    I have another question. I have an Epilog Laser and after looking at the CNC routers can you tell me honestly what a Laser can do that a cnc router cant do? Honestly I don't see much reason to have the Laser after I get the router because I will do all the laser will do plus a whole lot more and what I can do on the router that I have done on the laser it will be light years faster.
Showing Visitor Messages 1 to 3 of 3
About james mcgrew

Basic Information


CAMaster ATC 508

James McGrew Cabinetmakers


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
10-03-2011 2:23 PM
General Information
Last Activity
02-17-2018 6:08 PM
Join Date

1 Friend

  1. Mick A Martin Mick A Martin is offline


    Mick A Martin
Showing Friends 1 to 1 of 1