Hello,
I am shopping for a fiber laser that can engrave alpha-numeric characters in 304 SS rings (OD 1.25" with .060" wall thickness). I like the look of deep engraving since it best matches the hand stamping (and filling with lacquer) that I have been doing. My cramped hands need a break. By deep I mean deep enough to see some depth so probably at least .010" to .025". I am assuming I can get a nice black cutout area so no more lacquer will be required.

I am thinking a fiber laser with rotary axis. This is low volume 1 offs so burn time is not critical. Does anyone have any suggestions on specific laser type and/or a laser vendor that you have had good luck with?

All advice will be greatly appreciated as the selection of laser makers both domestic and overseas is a little overwhelming.

Thank you!