Really simple. This is one of those ‘looks way harder’ than it really is moments. Here is the blank being cut (Atlas/Patriot/Polaris). I stop the blade just a little before half way. It is at a 45 degree angle. And I have a stop block to ensure the segments are going to be even all the way around. Although I imagine you could vary the segment up and down the blank. You will notice that, because I like my fingers I don’t cut the blank to size until the swirl ...
(part 3 of 3) From this point treat the blank as you would any other pen blank. Here you can see the blank has been put on the mandrel/lathe and has started the turning process. After sanding and putting on a cyanacrylic (CA) finish and buffing… Here is the final ...
(Part 2 of 3) The next step is to cut some dark wood strips for the spacers. Just make sure you cut them long enough to cover the angle length on the sections you just cut from the checker board blank. This is what you end up with: The one thing I do is to make sure to sand off any chips and splinters off the sections. ...
My version of Ron McIntire’s segmented pen. This just happens to be the way I do it… that best fits how I think through the process. I’m sure there are many other variables in getting the same end. First of all I make a checkerboard blank. The one in this Tutorial is Paduak and Maple. (It works best with contrasting colors). The next step is to cut the sections in equal sizes. I ...
(Part 3 of 3) Now just put your pen together.