Originally Posted by Lee Schierer When I first started making better quality furniture, money was pretty tight back then and I had just purchased a new table saw. LOML always want raised panels on the doors and drawers. The only methods I could find on the internet that showed how to make raise panels, left a sharp corner on the edges of the raised part of each panel. One day after playing around a bit, I came up with a way to make nice raised panels that had a smoother transition from the beveled surface to the face of the panel. ...
(part 3 of 3) From this point treat the blank as you would any other pen blank. Here you can see the blank has been put on the mandrel/lathe and has started the turning process. After sanding and putting on a cyanacrylic (CA) finish and buffing… Here is the final ...
The aprons were up next and it was quick work to milling them to size and then it was adding the decorative touches. I had thought about adding flutes to the outside of the aprons, but decided to go with a walnut band of inlay around the outside instead and that would go nice with the minor walnut inlay that would be inlaid at each intersection of the top segments later in the construction phase. ...
I had had the leg set and the pedestal assembly sitting around the shop for quite a while. It was quick work to drill the holes for mounting the legs to the pedestal. First though, I wanted to make sure that the pedestal was square or else my hole layout for the leg bolts would be off. ...
I then reassembled the shutters and did a dry fit just to make sure everything fit. Here are the shutters in the closed position (no control bar or hinges... That's coming this weekend.): Here are the shutters in the fully open position: Here is a view from the outside: ...
Recent Comments