• Recent Polls

    Would you borrow a tool from someone? (Votes: 71)

    1. Sure - why not? (Votes: 9)

    2. Never. If I needed something, I'd buy or rent it. (Votes: 10)

    3. Maybe. Depends on the person and the tool. (Votes: 52)

  • Recent Forum Posts

    steven c newman

    Lumber supply

    Making Crispy Ash Noodles..yum..

    about every 3 pass, rub a bit of wax along the groove...tight squeeze..

    Had to make sure

    steven c newman Today, 6:18 PM Go to last post
    Bill Dufour

    SCM T130 bearing change

    My goggle came up with a Grob T120tp plane. I do not think it is the same Grob still making bandsaws in Wisconsin. Unlike many here I donot really know

    Bill Dufour Today, 6:17 PM Go to last post
    steven c newman

    Lumber supply

    During the Lay out..

    Decided to see what one side of the chest will look like...8 raised panels...to match the 8 drawers this will have..2"

    steven c newman Today, 6:06 PM Go to last post
    Rush Paul

    LLAMBRICH Intergrated arbor and chuck

    We have the Llambrich JK13-MT2 check on the Jet JDP-17 drill press in our community woodworking shop. Like Michael Burnside above, we absolutely love

    Rush Paul Today, 5:57 PM Go to last post
    steven c newman

    Lumber supply

    Since one end looked the best, I started there,

    Just hold them square...use one of the 2" wide rails...mark where the tenon meets

    steven c newman Today, 5:56 PM Go to last post