drill chuck for 0766

  1. Richard Demler
    Richard Demler - 07-13-2016, 2:16 PM
    Can someone recommend a chuck for the tail stock of the 0766? I don't know if they are all interchangeable but I would like to be able to drill out centers for urns...Thank you for any help..
  2. Mark Greenbaum
    Mark Greenbaum - 07-13-2016, 7:07 PM
    I have been using a keyed MT-2 jacobs chuck from HF ($8). Works well enough.
  3. Roger Chandler
    Roger Chandler - 07-13-2016, 7:24 PM
    Any Morse tapr #2 should work.
  4. Brice Rogers
    Brice Rogers - 07-13-2016, 7:45 PM
    I'm using the MT2 chuck from Harbor "Fright" also. Seems to work okay. I think that all Morse taper #2's are interchangeable (assuming the mfr knew what they were doing and adhered to specs that have been around for the last century.
  5. Richard Demler
    Richard Demler - 07-13-2016, 10:28 PM
    Thank you for the replies..I'll check into them..
  6. Richard Demler
    Richard Demler - 07-13-2016, 10:32 PM
    Are some just tapered with no slot?Will they hold and keep a bit from spinning if so?
Results 1 to 6 of 6