How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

cope and stick micro shaker?

has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

AC electrical puzzlement

This morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...

Drill w/guide or router?

Here's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...

Township building codes.

Any one know what the reason why a metal gazebo needs to be at least ten feet from the house? Per township ordnance :confused:

Arts & crafts pole lamp from quarter sawn oak

I felt like the lock miter would give me greater precision on the corners. Thanks brian

Glaziers Points Sizes

Thanks so much Tom for those points and the help guiding me through this. Just looking at repairing sashes, to the untrained eye you don’t see all work

Cordless Circular Saw Advice

I purchase the Milwaukee 18v 7 1/4 to build my retirement home. It comes with thin kerf blade that has hit nail or two still going strong. But! Even without

Cordless Circular Saw Advice

One consideration that’s not been mentioned so far is the increase weight of battery powered tools. If you’re doing a few smallish crosscuts

Rikon Lathe 70-1824

Is this the Harold Walsh I know from Lee Edwards HS?

SC Pig-Picking