I'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Jimmy Harris Today, 5:53 PMThey are going crazy building standalone car washes in my area. I know of at least three currently under construction nearby, and a few others that recently opened. Car washes are going up all over the Minneapolis metro area. There will easily be three times as many standalone car washes once...
Last Post By: julian abram Today, 5:43 PMAll these slider threads got me thinking. Does anyone here have the Harvey compass st-1500 attached to their unisaw? Can you speak on the quality, ease of attachment, capabilities and shortcomings? Thank you in advance!
Last Post By: John Kananis Today, 10:24 AMI have two exterior doors, one to the back of my house and one to my tool shed. Both are showing the effects of winter water splashing up on them at the base. The door to my shed is really bad. I don't want to replace the doors but would like to put a board over the base, like a kickplate to...
Last Post By: Stan Calow Today, 9:20 AMI glued up this oval Santos mahogany coffee table on Sunday. Yesterday morning, Tuesday, I placed it outside under cloudy skies in the hope that the UV to hasten the darkening of wood surface before finishing later this week. The center seam opened up. I used brand new T-88 epoxy with...
Last Post By: Mark Gibney Today, 6:33 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Yep, nobody seems to have any use for old MF or LF camera tripods any more. I picked up a tank of a Manfrotto studio tripod off of FB marketplace for
Michael Schuch Today, 6:39 PMAgreed Jim, and i didn't mean that to be a direct reply to you. Just an opportunity to remind that the motorized part of the tool is not always the key
Earl McLain Today, 6:36 PMMy dilemma is whether or not I actually use my DP enough to justify a very nice keyless chuck whereas. Or even to upgrade to a variable speed DP for that
Bill Dufour Today, 6:33 PMJohn I took it back inside the shop as soon as I saw it had opened up and left it in a quiet corner.
Mark Gibney Today, 6:33 PMIf you can draw the part in an appropriate graphics program there are a range of rubber-like polymers that could be used to 3D print it. https://rapidmade.com/3d-printing/3d...d%20Elastomer.
roger wiegand Today, 6:31 PM
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Today, 12:14 PM