Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Jim Becker Today, 9:42 AMI need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...
Last Post By: Matt Day Yesterday, 10:28 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Tom M King Today, 8:10 AMhas anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...
Last Post By: Maurice Mcmurry Yesterday, 5:00 PMI'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Jimmy Harris Today, 1:31 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
I guess it depends on how comfortable you feel making standard miters on furniture. Set your saw at 44.9 degrees and cut the miter. Glue together and
Michael Burnside Today, 1:32 PMWith all due respect, I think I understand a lot better what you're saying than you understand what I'm saying. And that's perfectly understandable.
Jimmy Harris Today, 1:31 PMEMC compliance is a serious thing.
mike stenson Today, 1:30 PMThe filters on those may say HEPA but they don't specify the rating or link their certificates, so I would be very weary of trusting them to filter dangerous
Michael Burnside Today, 1:25 PMWith these inside dimensions the cremains box fits nicely.
8 11/16 x 6 13/16 x 4 5/8
These are the inside dimensions of the
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 9:30 AM