I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...
Last Post By: Matt Day Yesterday, 10:28 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Tom M King Today, 8:10 AMhas anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...
Last Post By: Maurice Mcmurry Yesterday, 5:00 PMHere's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...
Last Post By: Rich Engelhardt Yesterday, 4:07 PMI'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: John C Cox Yesterday, 7:22 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
You see ads? None here, though I did remove cookies after reading the post. I'm using Firefox and Privacy Badger.
Steven O Smith Today, 8:36 AMInteresting, Maurice. I could have done it that way, but I was building to mimic the setup that Australian guy had on YouTube that he removed right as
Alan Lightstone Today, 8:36 AMYou can improve air circulation by using bigger stickers. If the stack is on ground start with concrete blocks. A few hours in the sun can ruin the wood
Tom Bender Today, 8:14 AMI have one pair of lineman's pliers that are also good strippers for 10 ga.
Tom M King Today, 8:10 AMThank you.....this is an entire different take on the issue.
Sawstop settled with Bosch in 2018 and they could have been selling the REAXX
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Alan Lightstone Today, 8:36 AM