I'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Edward Weber Today, 7:19 PMThey are going crazy building standalone car washes in my area. I know of at least three currently under construction nearby, and a few others that recently opened. Car washes are going up all over the Minneapolis metro area. There will easily be three times as many standalone car washes once...
Last Post By: julian abram Today, 5:43 PMAll these slider threads got me thinking. Does anyone here have the Harvey compass st-1500 attached to their unisaw? Can you speak on the quality, ease of attachment, capabilities and shortcomings? Thank you in advance!
Last Post By: John Kananis Today, 10:24 AMI have two exterior doors, one to the back of my house and one to my tool shed. Both are showing the effects of winter water splashing up on them at the base. The door to my shed is really bad. I don't want to replace the doors but would like to put a board over the base, like a kickplate to...
Last Post By: Stan Calow Today, 9:20 AMI glued up this oval Santos mahogany coffee table on Sunday. Yesterday morning, Tuesday, I placed it outside under cloudy skies in the hope that the UV to hasten the darkening of wood surface before finishing later this week. The center seam opened up. I used brand new T-88 epoxy with...
Last Post By: Mark Gibney Today, 6:33 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Do a search for "rubber bushings". There is a bunch on Amazon.
Ken Fitzgerald Today, 7:57 PMHIK has a much nicer belt (but i had spare leather belts) and a particulant pre-filter to help extend the HEPA life. I've just been using the HEPA without
Earl McLain Today, 7:45 PMUpdate:
-3 bessey deep clamps: $200 for all 3
1. Black 24” x 12”
2. Black 24” x 10”
3. Blue 20” x 12”
- 1 veritas
They make heat shrink anti-slip tubing for fishing rods that would probably work. Example: https://www.amazon.com/Greatfishing-...09&sr=8-5&th=1
Paul F Franklin Today, 7:39 PMGuys, I'm relatively new to wood turning as I've been doing it for about 5 years now as a hobby. I have a Jet 1221 and a few Nova G3 chucks. I've been
Art Dilione Today, 7:28 PM
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Today, 12:14 PM