Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Mike King Today, 10:32 AMI need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...
Last Post By: Geoff Crimmins Today, 12:08 PMhas anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...
Last Post By: Maurice Mcmurry Today, 5:00 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Tom M King Today, 6:42 PMHere's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...
Last Post By: Rich Engelhardt Today, 4:07 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
I wouldn't be surprised that if you asked on Craigslist, someone would give you one. Lots of those on shelves collecting dust.
Cameron Wood Today, 8:04 PMSo maybe that outlet in your old place was miswired for 220 volts.
Tom Bender Today, 7:42 PMI have at least three sets of four of the clamps, with the hardware . If you're still interested, let me know.
alan tasoff Today, 7:41 PM^^^^^^ This ^^^^^
I've done more resawing than most, and cheap/low powered saws are a terrible choice for any sort of thickness for resawing.
using logic trace I will show tracing out this graphic and creating a file
to vinyl print and cut then heat transfer this to a canvas tote bag
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Bert Kemp Yesterday, 8:28 PM