I don’t see myself needing anything like that. I have experience laying out large roof panels consider the precision that’s needed when your fighting...
I would take it apart and replace the bearings unless I was positive they weren’t done recently.
Cleaning up the dt ways might be just what’s needed...
There’s another wood movement condition to consider. Where the piece is sitting is there direct sunlight on on side during the day is it by a window....
Doing that would actually create a smaller saw than any job-site saw with the motor hanging out the back, retain the accruacy and most of the mass. ...
Roger that sounds like a good teacher. My first carving teacher John was very much the same. He used stones and a strop. Someday I’m going to try the...
I would like to share a simple Christmas mouse carving that can be done with only a knife. I’m also adding a pic of the pattern that I use to cut out...