Edward Weber
Contributor

Personally I would say that's a good price for everything I see in the photo.

A well made, close fitting joint, whatever it may be, requires less glue and is more important than how much pressure is applied. As it's been...

I have had momentary (less than ten seconds) power glitches. It gets your attention. I have a mag power switch on my TS and RAS, the lathe VFD...

I finally found a list that makes clear what is and isn't subject to the law. (my post above is incorrect) You might think this information would be...

IMO, Currently, Battery is good up to about 10 hp. The big gap between 10 and 25 is where all the problems will occur, like the above mentioned...

You mentioned a test, can you post a link to it?

As i was pointing out, if all you do is mow, blow & go, battery is a good choice. IF you have extensive mowing (1+ acre) or heavier than "normal"...

You do not need 4200lbs of pressure. Your clamp provides pressure accross a wider area than just ONE square inch. This may help you visualize ...

The cost alone is prohibitive, not to mention the lack of available equipment and the time needed to change out batteries and charge. Example,...

The only issue I would have with some of the solutions like Derek and Glenn shared, is that you need to remove them if you ever tilt the table....

Ah children, I understand

I have a few rules that I follow when it comes to dust collection. If you can't get it at the source, keep it contained as much as possible and...

Derek, I think you'll find that with a little deeper inspection and a little controlled persuasion, that the blade does indeed move. It may have...

"safety switch' is a generic term. Bill's method will work for power interrupt switches like magnetic. For those little yellow "keys" and...

Was this guys business rehabbing old planes or did he just want them all to himself? I get the chisels, they have a wide variety, the planes look to...

While I have no interest in sustainers, I find your situation and solution to be very altruistic.

Agreed, you're not alone, BTDT. Sometimes those "temporary" builds seem to last years and years.

This is my experience as well, Fruit-woods are notorious for moving in all manner of ways. Pictures might help to know if there were any visual...

Very nice as usual, thanks for showing us all your creations

Don't neglect to look at the air intake filter and associated items in conjunction with the fuel issue.

I prefer to make my own from wood. I find that too many retail handles are either too short or too small in diameter for my liking I use a dense...

In my research on them, it mainly depends on the manufacturer, some are anything over 2". Here are a few of mine, mostly 2" ones, 1" corner, the...

Systainers are just like every other proprietary tool brands storage system. if they work for you great. I don't work on location, only in the shop....

I can feel the difference too but most turning tools are typically sharpened with a hollow grind (straight off the grinder). I was referring to...

You did just start a sharpening thread, so hang on. IMO, neither makes a difference in the actual cutting of the wood. The difference is in the...

Depending on where on your construction (if they'll be seen), stainless "staples" are less prone to puling out.

They work both ways

I'm one who has never had a good experience with TimberWolf blades. I never found them to be particularly sharp, which then required more feed...

Sounds like what you really need is an air-to-air heat exchanger

3/4" x 3/4" doesn't give you a lot to work with. I would suggest looking at the hobbit house or the wood database and then figuring out what you...