• Dan Gaylin's Avatar
    05-19-2024, 11:06 PM
    Dan Gaylin started a thread titebond clamping force for wasteblocks in Turner's Forum
    I will often use a wasteblock glued to a bowl blank to maximize the depth I can get out of a blank. I have had good success using Titebond II to...
    see more
    6 replies | 345 view(s)
  • Dan Gaylin's Avatar
    04-30-2024, 3:12 PM
    Dan Gaylin replied to a thread Rikon Lathe 70-1824 in Turner's Forum
    Harold, I don’t think the headstock comes off. The manual is silent on this point but clearly describes an assembly process in which the headstock is...
    see more
    8 replies | 1706 view(s)
  • Dan Gaylin's Avatar
    04-27-2024, 11:33 AM
    Dan Gaylin replied to a thread Rikon Lathe 70-1824 in Turner's Forum
    Hi Harold, I, too, have been generally quite happy with other Rikon tools I have used/owned. I purchased the 70-1824 from Acme Tool. Shipping...
    see more
    8 replies | 1706 view(s)
  • Dan Gaylin's Avatar
    04-25-2024, 3:50 PM
    Dan Gaylin replied to a thread Rikon Lathe 70-1824 in Turner's Forum
    Hi Harold, I own the 70-1824, which in my view is a full size lathe, although one with a short bed. I bought it in October, despite there being...
    see more
    8 replies | 1706 view(s)
No More Results
About Dan Gaylin

Basic Information

About Dan Gaylin
Location:
Kensington, Maryland
Interests:
Turning, finishing,

Statistics


Total Posts
Total Posts
278
Posts Per Day
0.13
General Information
Last Activity
05-19-2024 11:08 PM
Join Date
09-15-2018