mike stenson
Contributor

What are we talking about? ;)

Yea, almost no glue strength in this case.

EMC compliance is a serious thing.

pretty much means that my sled's are not my final cut. Essentially, I con't care about their absolute accuracy. Because the shooting board will...

For joinery, a shooting board.

I wonder if using a punch to dimple the inner surface of the chisel socket would help.

I've had loose handles on my (gen1) LN's with the same frequency as my vintage socket chisels.

Sell them and get tang chisels. I only have that issue if I don't use them for a long time though.

My 5" drops are the same. 6" S&D > 6" blast gates > 5" reducer. I found some pretty flexible 6" hose that's going to my cyclones drum. I think it was...

You can source the hardware. I replaced a whole bunch of them on the awning windows in my house. Unfortunately, I still need to replace them as the...

I did the double stud wall with horizontally woven insulation at our last house. With that and double drywall on both sides, it was very quiet.

Those must be newer than a year.

They make attachments for drill presses to hold the chisels. I have one, I'd be happy to give away.

How is posting here giving a manufacturer feedback? Serious question.

I feel like this is the same either way in Arizona.

My wife wasn't a rural carrier, nor was a friend of ours. Both had that issue on 2010ish Subarus. I remain unimpressed with them in general.

That sounds like a stuck caliper, which was a potential issue on the Subaru's I worked on.

I also have magports. I couldn't use the woodpeckers or woodcraft ones because, as mentioned, 120mm tools. I don't find the alignment to be a huge...

I can tell people who don't work in a manufacturing, or product development, industry. Nothing to sell, and you got no company. This isn't planned...

Depends on the bias. My GTi wore rears much faster than front, by design. I think the OP isn't hitting the brakes as hard, or heating them up, the...

I'll take sealed, non-serviceable, bearings and having to replace them once for every 8th time I'd have to clean and repack non-sealed bearings.

This was awesome, when I had straight knives!

I sharpen my hand tools several times during use. Basically, I keep my stones out when using them. Reestablishing a bevel, removing a nick etc, with...

I find my tormek to be great for sharpening turning tools. Things like chisels and plane irons, faster with a normal bench grinder and stones....

Large power tools? Millwrights.

I agree, I only use the domino in a vertical fashion when I've got a fence clamped across the workpiece. But that means I'm registering against the...

So, dangerous for all but collectors.