Cameron Wood
Contributor

What about set, and kerf width? Some blades are sharp- they cut fast but leave a rough surface and a fat kerf.

I came up with an idea for peer driver feedback. Vehicles would have a small LED panel on the back with a receiver, and drivers could have a two-...

You are considering it in large part because of increasing emission standards and also buyer credits, support/requirements for charging stations,...

Solar panels generate electricity- I don't see a problem with that.

One was supposed to infer the irony emoji in my post. I have not heard a battery called a generator.

Thanks for the info. I did not know that there was a Tokyo Chisel Group.

I just got one from there the other day. I don't find much difference between the cheap bits and expensive ones aside from the guide bearings don't...

I'm about to try this- good reviews in recent discussion here. ...

As a kid, I found a large hook in the shed. I tied a rope to it and then thought I would hoist myself up by running the rope over a tree branch,...

Good point about generators. I got one earlier this year due to a downed tree epic power outage, and got a $300 rebate from the utility company. ...

Hollowing out the log to make a tube with somewhat uniform wall thickness and open top & bottom should work OK. The top & bottom could have separate...

Studies say the lawn is arguably the largest irrigated crop in the US, with more acreage than the the next eight crops combined (corn, wheat, cotton,...

Riding mowers is a different issue, but push ones do OK. Here in California, lawns are dwindling anyway, mostly due to water. The guy that takes...

There's the band saw upgrade discussed elsewhere; got roped in to hanging and installing an exterior door for my son- I replaced his entry door a...

"The hydrocarbon emissions from a half-hour of yard work with the two-stroke leaf blower are about the same as a 3,900-mile drive from Texas to...

Looking good. Putting the fastener box on top of the sandpaper is not bad as the weight keeps the sheets flat.

There are two approaches to the grain orientation: rift sawn, and flat sawn. The flat sawn I believe is more stable, or at least moves more...

Interesting, but I don't see the connection to Japanese planes.

IME, height is the main actual rule, with the rest to be worked out by the party or parties involved. Property lines can be tricky and expensive. ...

Santa Rosa, California

From the Craigslist post: "I've been a hobbyist woodworker and collector of woodworking tools for the past 45 years and it's now time to thin the...

I'm a fan of the tilde, since I often speak in generalities, or more precisely, approximatalities.

Oops, this was meant for 'neanderthal'.

I was going to say hot knife as well. I have clients that wanted me to replace their seal-failed glass panes in custom made wood windows. A bunch...

http://vintagemachinery.org/pubs/655/837.pdf For #66 but should be similar process. Here's someone who replaced the contactor with a...

This was part of a mixed lot of tools that I got recently. There appears to be a fracture in the cutting edge, which hasn't affected the light use...

Three passes with a beading bit in a router table should do it.