I suggest a two piece approach. Use a butt joint with the thinner interior section. Then wrap it with the thicker outer molded piece using 45's. Put...
If you resaw much you'll find dust collection is a key issue. You can get by with a shopvac on a saw that can only cut a few inches/minute, but once...
As he warns, it's not a good design if you want a large unit, which I proved correct. Not complaining; I knew I was in unchartered waters, and found...
Looks like a kit, so the joinery won't be heirloom quality. I wouldn't be surprised if it's put together with bolts and barrel nuts, which do a good...
Epoxy likes a rough, non oily surface and, as John said, a relatively thick glue line. Jointing the edge cleanly might not have given it anything to...