Register
Help
Remember Me?
What's New?
Forum
New Posts
FAQ
Calendar
Community
Groups
Albums
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Articles
Blogs
Donate
Sponsors
Friends of the Creek
Advanced Search
Member List
Bill Littler
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Bill Littler
Member
Find latest posts
Find latest started threads
View Articles
View Blog Entries
Mini Statistics
Join Date
06-19-2012
Last Activity
05-01-2024
3:07 PM
Avatar
More
1
Friend
Prashun Patel
Recent Visitors
The last 10 visitor(s) to this page were:
Baxter Smith
,
Jim Falsetti
,
Jim Reffner
,
John Hollaway
,
John Janson
,
Keith Mullins
,
Les Heinen
,
Matt Day
,
Ollie McDottie
,
Sonny Harald
This page has had
4,688
visits
Tab Content
Bill Littler's Activity
About Me
Friends
Tab Content
All
Bill Littler
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Yesterday,
3:57 PM
Prashun Patel
replied to a thread
storing kiln dried white and red oak outside
in
Sawmills and Kiln Drying
I missed "coming out of the kiln". I assumed incorrectly it was going onto the pile green, to be air dried.
see more
4 replies | 321 view(s)
Yesterday,
10:46 AM
Prashun Patel
replied to a thread
One Time finish for out door dining table
in
Project Finishing
I agree. I don't think this is a safety warning; it's a warning that it requires UV light to properly cure.
see more
6 replies | 268 view(s)
Yesterday,
9:22 AM
Prashun Patel
replied to a thread
Leopard bloosom
in
Turner's Forum
Wow, very striking. While in figure it's leopard, in shape, it's all lion.
see more
3 replies | 274 view(s)
Yesterday,
9:18 AM
Prashun Patel
replied to a thread
Other woods with unusual movement like seen in rainbow Poplar?
in
General Woodworking and Power Tools
Maple, ironically, can have this variation - especially when it starts to decay near the center. You should also look for "flamed" box elder. ...
see more
11 replies | 905 view(s)
Yesterday,
9:10 AM
Prashun Patel
replied to a thread
storing kiln dried white and red oak outside
in
Sawmills and Kiln Drying
No, that's a viable option. I did that and it worked fine. However, leave good space so you can occasionally blow out any bugs or debris that...
see more
4 replies | 321 view(s)
05-13-2024,
9:11 AM
Prashun Patel
replied to a thread
Adhesive with a long open time
in
General Woodworking and Power Tools
I've used System 3 T-88. It has about 45 minutes open time. I recommend it. However, you mentioned "complicated" glue up. Beware that 2 part...
see more
42 replies | 2322 view(s)
05-09-2024,
9:11 AM
Prashun Patel
replied to a thread
Stainless steel figure 8 hardware
in
General Woodworking and Power Tools
Google "Table top buttons". I've used this method a few times. You can use stainless steel screws to attach them. You need an easy way to route...
see more
15 replies | 1190 view(s)
05-08-2024,
8:41 PM
Prashun Patel
replied to a thread
Should I replane three week old edges before glue up?
in
General Woodworking and Power Tools
To test a panel joint, I slide post it notes between the joint at various points and then dry clamp them with "moderate force". If I can't pull any...
see more
8 replies | 1062 view(s)
05-07-2024,
10:21 AM
Prashun Patel
replied to a thread
Outdoor White Oak
in
General Woodworking and Power Tools
It will turn silver. Washing and oiling will delay the decay and possibly splitting. On outdoor furniture you can also epoxy any end grain -...
see more
11 replies | 861 view(s)
05-06-2024,
3:21 PM
Prashun Patel
replied to a thread
Dewalt DW735 Planer for short hardwood boards?
in
General Woodworking and Power Tools
I don't think the width of the planer has much to do with it's ability to handle short stock. Anything under 12" is a challenge to run through any...
see more
16 replies | 1257 view(s)
05-06-2024,
2:12 PM
Prashun Patel
replied to a thread
Charcuterie Board Handle
in
General Woodworking and Power Tools
Most ergonomic for me is recessed handles on the underside and felt or rubber feet to give a shadow line, help it sit flat better, and reduce slip...
see more
15 replies | 1142 view(s)
05-06-2024,
8:16 AM
Prashun Patel
replied to a thread
Outdoor White Oak
in
General Woodworking and Power Tools
Here's a white oak bench I made 10 years ago. I finished it initially with something - I can't remember. That lasted 2 seasons, and started flaking...
see more
11 replies | 861 view(s)
05-03-2024,
7:27 AM
Prashun Patel
replied to a thread
Creating an aged maple finish
in
Project Finishing
I'm pretty comfortable with dyeing and toning. I've done a fair bit of it, including matching and layering for color depth. I agree, the...
see more
21 replies | 3290 view(s)
05-02-2024,
5:21 PM
Prashun Patel
replied to a thread
Creating an aged maple finish
in
Project Finishing
Thanks for the follow up. I learned a lot on this thread. Mostly that coloring is not something I want to do ;) Thanks for the Minwax OMP review. ...
see more
21 replies | 3290 view(s)
More Activity
No More Results
No Recent Activity
About Bill Littler
Basic Information
About Bill Littler
Location:
Adair, IA
Statistics
Total Posts
Total Posts
34
Posts Per Day
0.01
General Information
Last Activity
05-01-2024
3:07 PM
Join Date
06-19-2012
1
Friend
Prashun Patel
Moderator
Showing Friends 1 to 1 of 1