William Hodge
Contributor

The chisel bevel angles vary quite a bit. I buy assorted cone shape stones that go into a drill. I change the angle on them by spinning them in a...

Tom, It's great to see someone matching existing sash, through tenons and all. No Dominos and epoxy.

I have a little Dust Deputy cyclone on a 55 gallon drum, all outdoors. The 55 gallon drum really seals tight.The exhaust has some fine dust in it, I...

Here's a profile from a shaker building. These are custom cutters, but the profile is a copy of an 1840's Shaker sash.

I use an Ultra Clean central vac. It's great for the floor, sanders, rip saw, etc. Air Flow: Air flow of 135.2 (CFM) cubic feet per minute...

The points for narrow rabbets are #1 diamond points. ...

I agree, 2" truck straps work great. Pad the laminations with some bending plywood. The note above warning about sanding wood to be machined is...

Try using The Google. "Sossry" is right there. I never knew, hadn't come across it, added a new facet to this jewel of a day. ...

The choice of wood can depend on the amount of water hitting the screens. Some screen houses have pretty good over hangs, and the screens don't go...

Sounds like a great project. Saw it into lumber now before it dries out and checks. This is what sawmills near me do. My round wood fire wood...

It's easy to mock someone doing stunt cuts, but this person can look ahead. If you're going to risk amputating fingers, cut them off ahead of time so...

OWWM will get its collective panties in a twist at the mention of a Grizzley machine.