When a blade is burning wood in a cut, it's getting a lot hotter than 100C. So a quick boil should be safe.
Carl
Type: Posts; User: Carl Hunsinger; Keyword(s):
When a blade is burning wood in a cut, it's getting a lot hotter than 100C. So a quick boil should be safe.
Carl
Not if I had one, they couldn't. Maybe a non-brake retrofit cartridge wrapped in a check for $1000, then maybe we would have a deal.
Carl
It's replies like these where we need a 'like' button on these forums:
... Being 6 inches tall I would say yes, that is way too high. My Ridgid is 37" high after the mobile base, and it feels...
But that's not how the Sawtop works. It's the blade stopping (and only the blade stopping) that retracts the blade. If the blade doesn't stop, the blade won't retract. So it's not a redundant...
So, a woodworker goes into a bar, holds up two fingers and says "gimme three beers."
Carl
Holy crap! I've seen and probably done some dangerous cuts....
Carl
Indeed. Another ER statistic averted.
Carl
My wild guess as to what happened is this. 1) the brake fired due to staple 2) OP examined the dado stack, saw no apparent damage, and replaced the brake and reused the dado stack 3) Note that I said...
I have a microjig splitter that I never used. PM me with your address and it's yours.
Carl
Just my hang up, maybe, but if I were ever searched either coming or going, that would the last time they would ever see me.
Carl
It's actually possible he could suffocate himself, if he has a gas water heater in the shop. I'm just sayin'...
Carl
I think Red Green already did this...
Carl
I think ultimately the bypass mode DOES make the SawStop safer. If the bypass mode was not available, I would never have bought a SawStop. Instead, I might have ended up with a 1949 Unisaw. I suspect...
How can a push stick be safer than a SawStop? The whole concept is, you have the SawStop technology watching your back, WHILE you use the guard, riving knife, and push stick. In my opinion, only a...
Definitely not a monopoly, but I'm convinced there was collusion in an attempt to make Gass go away. I am thoroughly enjoying the current situation where those who colluded against him are now...
I believe the K4 exists because of a patent infringement lawsuit regarding the clamp on the K3. I think it has since been resolved in Kreg's favor,but it was too late for the K3.
Carl
Ed-
Please let us know what you find out from SawStop.
Carl
I'm surprised you haven't gotten any replies to your question yet. If this were a certain other forum, you would have already gotten a reply from a certain person who has made "hat,n" the SawStop a...
Are these by chance the counterfeit Square-D breakers I've heard about lately?
Carl
I bought a Dremel blade at the Borg and it does NOT fit the HF variable speed multitool.
Carl
Do you have Chinese drywall nearby that could be corroding things?
Carl
I have both of those books. Pure gold!
Carl
In fact, two motors, one a 2 hp, and the other a 5 hp, will draw the same power at a given airflow (since the speed is the same, and assuming they have the same efficiency rating). As blast gates...
This isn't true. Clamp an ammeter over one of the hot lines to the machine, close all blast gates, and you'll see relatively little current draw. Now open one of the gates, and watch the current...
My advice is to get the integrated mobile base. One advantage is the saw sits on its base when lowered, and when raised, even the extension table raises with it - no need to extend the base under the...