Search:

Yes john can you send link, an article that addresses "box joints on large stock' would be helpful.

thanks.

Thanks for the good idea Doug, I like it and was typing my reply not to you directly- we were both typing at the same time!

Edwin yes just also looked at the large Keller. Just seems kind of...

I have now found a commercially available jig that can make half blind DT's in a single pass.

Perhaps I can use the 6 footer on the horizontal and since the other board is only 24", i will put...

Ok thank you, it seems like a Leigh dovetail jig is the simplest way to go. I will make a station for it that will allow for 72" to hang below it. I may also make DT's as well as box joints because I...

Well i guess I would be in agreement that yes, it is far better to move the tool, as opposed to the large work piece. Thank you for replying- hope someone has used a dovetail jig in a position other...

Hello all, first post...

I searched my question and found a "nearly" adequate answer from a thread here dated 2009. I would like to revisit the problem and ask for some more specific answers.
...