Please count me in!
Type: Posts; User: Scott Loven; Keyword(s):
Please count me in!
Please count me in!
Please count me in!
Please count me in!
Please count me in!
Please count me in!
Please count me in!
Please count me in!
Please count me in!
count me in!
I would look at it this way, what would it cost her to buy new and replace? If it can still be purchased to match the existing, suggest that she do it and that you do the install for $100. To...
I find it hard to balance the lap-top on my knees in the reading room so still prefer to buy hard copy magazines!
Scott
I like the Milescraft feather boards as well as the bench dog line.
Scott
How about cutting a deep saw kerf underneath about 2 inches back from the front and glue a piece of steel in the slot. Should make it much stiffer and almost invisible. I also would do a dado on...
count me in!
I was just thinking about some sort of insulated blanket that could be put up for the winter and taken down when warm, or if you needed to use the big door. I have a 10*10 steel insulated door with...
There was a Fine Woodworking Joint test a while back that was very favorable to Pocket hole Joinery. If I recall correctly it really gets down to penetration from one piece of wood into another. ...
"PS -- Personally, I think it's ridiculous to keep chickens when eggs are a buck a dozen. But it makes her happy, and I've got to come up with a strategy. "
Ya, its like those people who spend...
Don't forget about the new router table lift!
http://www.kregtool.com/products/prs/product.php?PRODUCT_ID=118
It seems like it would be worth it if you do cabinets for a living. Time is...
How about putting a reminder on the crank to remove the insert before you tilt the blade? A piece of plastic pipe perhaps?
Scott
Kreg is also coming out with a new smaller drill bit and jig head and smaller screws for 1/2 inch material. The jig head will fit the K3 jig body.
Scott
I have a Dewalt RAS with a break that doesn't work. I was thinking I could add a disk brake from a bicycle if it bothered me. I could not find replacement parts anywhere.
Scott
Spend the two hours and make the drive to Grizzly after you have looked at the HF unit.
Scott
I see that they are headquartered in Madison Wisconsin now, do they have a retail store there? When did this happen?
http://www.mcfeelys.com/
Scott
I suggested to Kreg tool that they make an angled plug hole cutter. If you had one you could cut a plug with the proper grain orientation out of scrap wood from your project. Should be much less...