Search:

Thanks Mark, as you seen in my previous comments, the only tag I have is actually on the table top it self, and nothing on the cabinet.

and what model is yours Mark?
Is yours a two speed?

Mike, thanks, I totally understand, I am finally back on my feet after sinus surgery a couple weeks ago...
Just back from the shop, not seeing any bolt other than what looks like a compression bolt...

thanks...
Now back to the two speed thing, have you seen the double sheave for the motor? I just went out and measured the the single motor sheave and its circumference is about 23-3/4" ~ 24" and...

Thanks again Mike,
another question, I've seen a few adaptor kits to bring the shaper bit shaft up to a 1", I know that there are a Ton of 3/4" bits out there, does it make sense to go to a 1" ever?...

Thanks Mike,
One question, you think that I have a 43-340, when I follow your link to the parts breakdown, it shows the two pulley design on the spindal, BUT, it also shows the two pulley design on...

Thanks Ken, I'll go over there and register to see if I can get an answer there.

ok all here is some photos.311553311554311555311556311557

so the first photo is the only numbers I can find on the out side ANYWHERE
Second photo is overall front view
third showing rockwell...

Hi folks, I need some help identifying my new to me Delta Rockwell shaper. It has a 3/4" and 1/2" interchangeable shaft.
I have surfed all over and not had much luck finding my shaper, the only...

I was wondering if anyone has built the router milling machine that is in the current issue of shopnotes?

Here is a video http://www.shopnotes.com/issues/115/videos/router-milling-machine-video/

Yes the cuts are good, but if I am going to the extent of checking EVERY THING, then I wanted to know...

thank you all for your input.

that is what i was looking for, thank you so much...

the only question I really have is, is the .002 acceptable wobble in my blade... the 5 cut method is close enough to perfect, but I only use that method for checking fences, sleds and miter gauges......

I have a Craftsman model 113-298843 contractor saw and performing alignments after receiving a new Delta T2-30 for Christmas.
Since I have never really checked every thing before, I decided now is...

Thank you, I think that is what I've been looking for.

Both are on sale, and interested in purchasing one of the two. Can anyone provide feedback on either?
Thank you in advance!

Nice work, I just may have to get busy drawing up something like that...

Nice work on the table, if I could only get my wife to give up the garage, the I too could have a shop like yours...
:)

I am building a blanket chest for my wife, no, thank goodness, not for Christmas, and I am looking to put an air tight seal on it.
I have seen in the fancy furniture stores, there is some type of...