I've built and now stained a bench that has so far turned out great, but not I'm at a place I've never been before...
I have to choose a finish for over the stain LOL
So far all of the pieces...
Type: Posts; User: Lean Angle; Keyword(s):
I've built and now stained a bench that has so far turned out great, but not I'm at a place I've never been before...
I have to choose a finish for over the stain LOL
So far all of the pieces...
I've been looking into DC lately, and I've been planning on putting the unit in a shed just outside my shop.
I'm curious about the benefits of a cyclone when the DC isn't even in the shop. My...
I think that the issue is that it is very hard to determine if you're getting a quality tool or not.
I'm going to go out on a limb here and say that there is better chance of getting an inferior...
I know for instance that I don't usually bother to look when I buy clothes. I guess I'm not really as concerned about the quality, that and its almost impossible to find clothes made in this country.
Cars are very tricky. A lot of times you don't know where its made unless you check that particular vehicle's markings. And who knows where the parts were made.
I don't worry about where the...
Anytime I shop for tools, I am pretty sure I pick up just about every one on the shelf looking to see where it is made. I more or less refuse to buy anything chinese, and I always try to find USA...
Just last week, I was building a lumber rack, and glued up the supports facing the wrong direction. Boy was I pissed!
It's not about being dumb, but sometimes you rush a little, sometimes you're...
I bought a craftsman 12" slider that I kind of regret....and that regret is actually not stemming from it being a craftsman :p
The slider just takes up too much room in my shop, and it is too...