Any idea why my machine would not go lower that a 17 mm/sec speed setting via software but will go as low as 1 mm / sec from the control panel.
I need to cut some thick material and have to do 2...
Type: Posts; User: Martin Coetzee; Keyword(s):
Any idea why my machine would not go lower that a 17 mm/sec speed setting via software but will go as low as 1 mm / sec from the control panel.
I need to cut some thick material and have to do 2...
This is exactly what I did....................... I ordered as "per Rodney spec" and all turned out well. So it just proves that it helps to first speak to the people that has gone thru the mill...
I had the same problem and it turned out that the set screws on the X axis pulley were not tight enough, causing the shaft to slip inside the pulley. I discovered this by grabbing the X axis beam and...
John.
Is it not an option for you to re-install XP Pro ( From the original disk belonging to the bust puter, and register with MS ) as a dual boot system and get your Corel 10 working again until...
Rodney,
I see in the manual that you sent me that mention is made in a section of certain passwords to be entered. Can you explain ?
Great ! By the time we are finished one can fit the machine into your shirt pocket !
I have checked with Shenhui and they confirm that the new machines can split below the tray, so this should not be a problem.
I shall just be careful to make sure all moving parts are secured...
Pretty decent of them to go to such trouble to get a few $'s to you.
Turning the machine on its side will not damage the insides ????
Further..........I guess there is no way I can get a 1200 x 800 machine through a normal house door !!!!!
Hi Rodney,
What is your experience with Shenhui.............do they install all the upgrades and "nice to have" as standard on new machines as I am ordering today/tomorrow and do not want to have...
Hi Rodney,
Am I right in assuming the machines are on castor wheels ?
Hi Gregor,
I am in exactly the same boat.
I am at retirement age and have decided to keep myself busy and amongst other things decided to buy a laser to do some engraving and cutting and earn a...
Pity the timing is not right otherwise you could have slipped a laser into the container for me !
I am new to this forum and trust I can learn a lot from you guys ! :cool:
Located in Rustenburg NW South Africa.