Search:

Phillips Forest Products in Dekalb is about 35 minutes from Mt Pleasant. They carry a good stock.

I have a G0691 that I've had for about 2 years. I went through the comparison between it and the 1023. I didn't decide until I was looking at them in the Grizzly showroom. I believe I would have been...

I used the 18" slides on my table as shown in the plans. There is some leftover space in the back. I believe you could use the 20" slides.

You don't have to install start page. Just don't check that box during install. I've used Waterfox for some time and like it.

Sent you a PM.

I've always bought direct from Dell. I've had good luck with their machines. I've bought my last few from the "Dell Outlet". Typically, these are machines that were purchased and returned. You...

I went through the same decision in March. I drove to Springfield to Grizzly thinking I would buy the 1023, but wanting to compare. After looking at both and talking to a very knowledgeable...

Figure me in.

My shop has metal siding and roof. I have no problem with reception inside. I'm not sure exactly how far I am from the tower, but reception is good in the entire area, so it must be nearby. Inside...

You didn't say what version of Word you are running, but later versions are pretty aggressive about blocking macros and VB code, especially from other users. I'm assuming that your button triggers...

All NEMA "6-" series plugs are intended for 220-240 volt (2 hots and a ground). "5-" series are for 110-120 volt (hot-neutral-ground). So no, you can't change it.

The current issue of Wood magazine has a review of benchtop mortisers. The Powermatic 701PM was rated their top tool. The Grizzly G0645 was rated top value. If you are considering buying one,...

I personally have mine with State Farm where I have my homeowners and auto.

As an alternative, these people are highly thought of by a number of people on a bass boat forum I frequent - they may...

I have purchased from Amazon warehouse a couple of times. It's worked the same as buying from Amazon, but sometimes the stuff is in damaged packages, returns, etc. I have never had a problem with...

http://www.quickscrews.com/Part/12239

I don't know if it is a supported use, but I do it all the time. My data file lives on my desktop and I access it from both my laptop and desktop (only one at a time). I've never had an issue.

I have Quicken 2011 installed on both my laptop and desktop. The laptop is a Dell 15R with Windows 7, 64 bit Home Premim. The desktop is an older Dell with Windows XP SP3. Quicken 2011 runs fine...

Try http://www.gmpartsshop.com/. I have used them in the past for GM hard parts with good results. They tend to be better on shipping than GMpartsdirect.

I've been browsing this forum for some time and have picked up a lot. I haven't posted because I don't really have enough experience to help others yet.

I recently retired after a little over 30...