Does any one have experience with this CNC routing device?
Type: Posts; User: Rick Frye; Keyword(s):
Does any one have experience with this CNC routing device?
arbor press is your friend with appropriate tooling
Take some tools and a camera with you. My solution in the past with heavy equipment such as a Delta DJ-20 and a Unisaw with a 50" fence and table has been to take good pictures and then a partial...
My solution is to use a slurry of Barkeepers Friend and WD40 also using the Scotch Brite pad and the required elbow grease.
Check this link, standard only...
http://www.buy.com/pr/product.aspx?sku=223536445&sellerid=21200627
While I do no have anything as nice as an MM20 I do have a 20+ year old S45 MM and when the original blade guides went south I found more than adequate replacements from Carter. YMMV
Western North Carolina
Some time ago I remember seeing plans for either an extruding device or break made from mdf to fashion aluminum flashing to form repair house wrapping parts. Now that I need to make one, I do not...
This site sells some that appear to be like the ones used by the T-Jack cabinet jack.
http://www.leansupermarket.com/servlet/Detail?no=124
Count me in!
Thanks
I was at a Lowe's an asked for several sheets of osb to be split in two.. the associate about went through the complete inventory before he got 8 parts that were 24" wide each??????
Sandy Mush, NC
Almost forgot just down the road from Sandy Much there is:
Frog Level, NC
Please count me in too......:)
If you do not disconnect the cable before a storm be ready to exchange either the network card or power supply just from experience.................:mad:
I made one of these several years ago. It is extremely accurate. You can even cut box joints without a dado blade, or create varying spacing. Just do an internet search on "Lynn Sabin's basic box...
Last summer I picked up a 1989 Brazilian Invecta DJ-20 for $350 at an auction (GLOAT) , after a little clean up and readjustment, runs like new. I sold my old North State 8" jointer for $450. After...
I bought a new Unisaw in 1992 with a Marathon motor. It has worked well with no issues for years now (52" commercial Biesemeyer fence and all). A few weeks ago I was at an estate sale and as a...
Almost 15 years ago I had a very good quality Amana blade that I had sharpened locally. When it came back, my chain saw made a better (read smoother) cut than the freshly sharpened blade. Check for...
Weldwood Resorcinol Glue, good for exposure to fresh and salt water. Been used for years in the boating area.
I got mine at Northern Tool. Cheap, seem to be good quality. They have been in service for about 3 years now, no issues.
The easiest to recover with is a "ghost" image of your hard drive onto another hard drive of equal or greater capacity. In the event of drive failure, it's as simple as swap the drive out, restart...
In a world of if it can go wrong it will, why chance it. And besides, what if you someday get a different router for the table, then there is the poor 3000 with a clipped cord.
what is up with new global economics?
I did a Google on "hand saw till". Will post photos of the unit I built later.
http://images.lowes.com/general/f/finish_chems_linseedoil.jpg
Boiled Linseed Oil, used as a finish. Found at both Lowes and Home Depot, and paint stores, etc.