I could be wrong but that’s for auto body shops only.
Type: Posts; User: John Beonme; Keyword(s):
I could be wrong but that’s for auto body shops only.
Won’t the waterborne stuff cause the MDF to fuzz or swell?
Makes sense.
I just looked for an ML Campbell retailer and the nearest one to me is 25 miles away. That's an hour drive here in Los Angeles. If it was for my kitchen or anywhere inside the house...
Sounds like Ill be going with post cat. Whats a good primer to use with that? Is zinnser BIN shellac good or is there something better with high build?
What are the benefits of post cat vs pre cat outside of shelf life?
Jim,
What are some of the safety requirements for lacquer? I have only sprayed BM advance, which I did outdoors and always used a respirator.
I have a couple gallons of bin shellac left over from another project. As for BM Advanced, I have sprayed it a bunch of times and do not want to use it due to the long drying and recoating time.
Hi Everyone,
I'm almost at the process of finishing my cabinet doors and wanted to know what products are needed to achieve a high gloss finish like you find in painted modern furniture. I'm...
This is definitely the best option but I can't justify spending that much for something I will occasionally use.
I prefer to get a plate so I can change out collars as needed. Wouldn't PB be bad to cut the grooves for t-track?
Jim,
I just remembered that I have a full sheet of 1.5" sheet of acrylic. Would it be possible to use only that? Though it may be kind of ugly, unless I can still cover it with Formica.
Hi Jim,
Are you referring to a torsion box frame? I've seen a few posts where people were doing that. What kind of solid wood should I use? I have a bunch of 3/4" plywood boards I can also cut into...
Hi Guys,
I recently purchased a 34-802 Type 2 Unisaw with a 52" Unifence. There was a a PB attached as the extension table but since it was damaged in transit I have completely removed it. I would...
I'm going to get adjustable metal legs and keep the cabinets off the ground. My garage is graded 2" from the cabinet height on the right side all the way to 5" off the ground at the left side near...
These will be wall to wall cabinets in the garage so I'm not too worried about screws showing. Everything will be screwed into the wall and the bottom units will have legs. Everything will be 24"...
Which connection is better when building two side by side 84"H x 30"W(60"total) x 24"D pantry cabinets out of melamine? Would there be a difference in strength?
363342
Hi Joe,
Does any place sell the Centor hardware to consumers? All their links are to door manufacturers.
Hi Victor,
I already priced out Ikea and Lowes. The killer is the 3 pantry size cabinets which are around $600 each at both locations. For a bit over that, I can buy the material for all the...
Hi Robert,
Thanks for all the recommendations. I've added the tools you mentioned to my list.
I wanted to stay away from a toe kick because my garage has a slope which is 6 inches high on one...
Hi John, I'm not sure what you mean by this. Are you referring to the cabinet legs? What do you mean by wrapping it in rubber?
Hi Everyone,
I'm new to the forum, but have been reading older posts for a project I will be taking on for my garage. I would like to build a set of cabinets along the entire wall of my garage as...