The wood is alder.
The finish is a three step ( stain, toner, glaze and then lacquer top coat.
Thanks for looking
Joe
Type: Posts; User: Joe Grout; Keyword(s):
The wood is alder.
The finish is a three step ( stain, toner, glaze and then lacquer top coat.
Thanks for looking
Joe
remove this post
http://www.woodworkersweb.com/modules/gallery/albums/albur26/10_23_04_Entry_door_and_bookcase_026.jpg
The finished case
...
What is the harm in that?
I could easily come up with several hundred "handles" that would appear as fully common names, The humor would only be on the inside for me to enjoy.
I mean how...
Have you ever used a 16" asian import jointer? Ignore the cheesey blade guard and give me a good reason why you think the European machines are such superior machines.
like the parallelogam set...
From the Sunhill page
# Segmented aluminum spike rollers provide a “sure grip”.
It would be fine for rough work, even on a jointer before planing
I don't hink the spike holes would be all...
I just use a straight edge of the outfeed table....spin the head by hand and move the straight edge,
Hope you use aluminum straightedge. :o
I should say that with a DJ20 there are jack screws...
Lay a piece of softwood ( pine/alder about 2" wide on top of the center of the knives. Hold down with one hand, tighten bolts in increments with the other. it should take about three passes to get...
I actually feel for David and would not get down on him too much for his finishing practices on the show. They give him 20 minutes to buld the piece,and put finish onit what could you expect.
...
Chris
It is going to make you pocketbook lighter ;) that is for sure.
I do not promote the use of Byrd heads on machinery due to the cost of the initial investment, futhermore while it creates...
Chris put the straightedge away you are going to knick those knives.
The suggestion that you use a straight stick for setting the tables and the knives is the best solution there is.
I post...
Dale
S4S is the acronym for Surfaced four sides, not sanded.
That means it is run through a double planer and is straight lined ripped ( possibly edge surfaced). So while I feel your pain you...
ciphering the radii isn't as bad as you may think. The trick is to start on the outside (largest) one and deduct for each new radius untill you get to the smallest.
And you are correct , I...
Ken, That is quartersawn white oak The dimensions are 7/8" thick by 37 1/2" wide by 18 3/4" high The raised molding is 5/8 by 1" wide. I did all the radiused cope and stick cuts on bearing guided...
Built this last Friday
That happens to be the one that I have and I haven't had any problems with it in the six years I have used it. It has not sagged, not gone out of alignment and the fence ought to be checked on any...