Search:

Thanks guys. I think that the bottom rails are 1 3/8" by 3 1/2", milled down from 6/4. I attached the bottom with lag screws every 12 to 15 inches or so. I think that I have a total deflection...

I have been working on this for the last couple of weekends. It is hard maple with a little bloodwood for strength. I also got some phenolic plywood to use for the top, base and sides, the rest is...

Hi Jim,

I just ordered one for mine that is on the way. I went to Incra's website and found out about thier new direct order website at www.incramentaltools.com . I am not sure it this counts...

Thank you for all of the compliments. I am truly humbled.

Well, the baby decided to arrive on his due date Saturday morning. I didn't know that I could be so tired... He was a healthy 7...

OK, I can't keep it in any longer. I am one of the monthly winners for the Woodcraft contest with the crib and dresser/changing table I built. And I guess this will be my first tool gloat; I was...

Thank you for all of the compliments. I do have to give credit where credit is due. It was my wife who suggested that I do the drawer fronts in solid Birdseye maple instead of maple plywood with...

Hello everyone. I have been lurking here for some time and I am finally ready to post some pics of my recent work. I really just got started into woodworking again in the past 2 years, and then...

Here are a couple of pics of my setup. My disconnect supplies power to my tablesaw, dust collector and my air compressor. I use the disconnect only to cut off the power to the air compressor only...

Hi Chris,

I think what you should do is run a contactor type switch (like what is on your air conditioner or heat pump) or a disconnect type switch for you unit. I am a HVAC mechanic and work...

Hi everyone. Is it possible to mount a router plate in the optional Sawstop table extension? I am getting one in a couple months and that is what I was hoping to be able to do. If it isn't...