What about aluminum? I can't imagine that the oxidation products of aluminum would react with the wood, plus it is cheap.
Type: Posts; User: Stephen Tebaldi; Keyword(s):
What about aluminum? I can't imagine that the oxidation products of aluminum would react with the wood, plus it is cheap.
Thanks, that is what I thought. I just wanted to make sure that if the bottom and top of the cabinet (as well as the shelf) all had the grain running in the same direction the expansion of all three...
I am building a cabinet and am trying to figure out the joinery. The top, sides and bottom all have the grain running in the same direction but are different thicknesses. Is wood movement generally...
I would agree with Ron. You will get some improvement, but probably not much. You would first have to determine how much vacuum you could draw with one unit and absolutely no resistance. That will...
I just finished doing my floors and I used the streetshoe which is supposed to be the bona traffic competitor. Like was said, it is a waterborne finish and went down pretty clear. It was definitely...
For preparation we rented a drum sander and edger. We used 30, 60, 80 plus a 100 screen on the entire floor. We used minwax ebony stain which we were leaving on for 5-10 minutes and then wiping off....
So I checked the stain with a white microfiber cloth this morning (almost 48 hours after application) and with moderate pressure I am getting some stain transfer. Is it possible that not enough...
Those were pretty much our thoughts as well. We went in last night and did the vacuuming and saw that the stain was still coming up a bit so decided to hold off until we check the stain again...
I am refinishing my floors and did all the sanding and staining this weekend. I was hoping to get the poly finish (streetshoe) done this weekend since my wife and I are now living in the kitchen so...
Thanks for the advice. The finishing was going to begin this weekend but the timing didn't work out. We decided to do it in two stages since it was the only logistical way to get it done. It will...
I am going to start refinishing our hardwood floors (were covered with carpet) this weekend. Ideally I would like to get the entire house done in one shot, but without being able to move all of our...
I would tend to agree. I have been using my 4511 for a little over 3 months now and the fence seems fine. I put a sacrificial fence on so it isn't possible to line up the measurements anymore, but...