If there is a machinist in the congregation, get him to turn something out of brass for the mating parts. The part into the floor needs to fit in a Forstner bit hole.
Type: Posts; User: Tom M King; Keyword(s):
If there is a machinist in the congregation, get him to turn something out of brass for the mating parts. The part into the floor needs to fit in a Forstner bit hole.
Sorry. EGO not echo. On phone
3different brands of cordless, 2 corded, and one 13hp gasoline on wheels.
Get the biggest Echo you want to spend the money on.
I have one pair of lineman's pliers that are also good strippers for 10 ga.
:DDid you grind that or did it test a hot wire for you?
I'll send the points out tomorrow. I should still have your address in my PM's.
You pull that loop up, drop the points in, and put the spring loaded loop back on top of the points to feed the...
I've used these needle nose pliers dedicated to one job since the 1970's. I ground the groove so that a twist of the wrist forms a perfect half loop for side wiring. I think every new house I ever...
Even the 1974 house that I bought for a rental, which was considered a tear-down, has 12 ga. wire in the receptacle circuits. That's the one I had trouble with those back stab devices in.
Also,...
https://www.ebay.com/itm/375393173271?itmmeta=01HWBGKP61S8B36V1E1XA1WYJ8&hash=item57672d3f17:g:770AAOSwwmhmKDqO&itmprp=enc%3AAQAJAAAAwMDi2iXcypvPpFjo9fX0uVcWkzAxlDNOXr4ZcRnXF%2F02mFRD1CDg2kMoBGTD9NxhV...
I’ve never used no.14 wire for any receptacle circuit. Don’t remember ever seeing a 15 amp. Receptacle circuit.
Those prices are nuts!
No place for juvenile wood before any other consideration.
Probably depending on how hard the wood is. The gun makes it very fast and easy.
The points used in my pictures don't have those right angle wings like push in points do.
Here are my pictures from that other thread-sorry all sideways. Muntin is 5/8" wide. Part the points are shot into is 1/4" thick.
Search for vintage glaziers points on ebay
Probably ebay
I think I put some pictures of those in your older thread on this. They’re pretty tiny. I never use the push in points for that very reason.
I only know of the small ones used in the old Red Devil point driver guns.
Looks fantastic!
Can’t edit on phone. The little levers throw the locking connector over center and are not going to release until the lever is thrown the other way.
I have a 24" bandsaw that I keep a 1" blade on, but my most used bandsaw is a 65 pound 10" that keeps a 1/4" blade on it. If you're going to cut a lot of that 8/4 Maple, get a big one. If not much,...
I don’t know when they finally went out of favor. I never used them in any of the house I ever built.
I’m thankful that what we have here is zoned agricultural. No permit required to build anything to house tractors or equipment and no written rules about converting these buildings to something...
Looks like this place has a couple of the Trim-O-Saw's for sale:
https://industriallynx.com/hammond-g100-glider-trim-o-saw-glide-table-saw-for-trim-28-fence-1hp-3ph/