You will get a little steam that is why you need to do a couple of test runs for water level. We have found that about 1/4" below the ABS will not leave any water residue. The impurities in the...
Type: Posts; User: Jerry Beltramo; Keyword(s):
You will get a little steam that is why you need to do a couple of test runs for water level. We have found that about 1/4" below the ABS will not leave any water residue. The impurities in the...
We cut a lot of ABS - 1/4" stock material, one pass. We originally purchased our laser to assist in manufacturing a woodworking product. We began using the vector table but have gone to a water...
Robert,
I have had the same issues with my 36 Ext Epilog. Have replaced the laser tube twice and every board in the unit. Several motors have been replaced as well as the arm. I thought maybe...
Why even think about buying a tenon jig. I have used loose tenons for years, which is a good way to use up my scrape lumber. Seems to be just as strong and much easier to line up the mortises and no...
We cut and engrave lots of acrylic. We remove the paper from both sites and have our settings as to minimize any smoke residue or flame up (we have a larger laser so settings will most likely not...
One router that has not been mentioned is the Triton. I would rate it up there as one of the best. I do a lot of fine wood working and think the Festool is way over rated (even though it is a good...
Robert,
If you want to give me a call tomorrow I may be able to help you with this issue. I have the same exact laser and we laser both anodized and hard coat anodized aluminum. We have also...
We have lasered hard andozied aluminum on a wood working fixture we manufactur for three years. The hard andozied aluminum holds up well with the usage of this equipment over time and the engraving...