Search:

Hi guys,

I appreciate your responses about using an auxiliary fence, but I'm not sure that would work with a cathedral style panel. Would that not only be feasible for a simple arch of a single...

Hi All,

I'm about to make several cathedral style arched raised panel doors for a kitchen pantry and have become uncertain about the safety of using the Freud 2+2 ogee style raised panel bit...

Hello All,

I've got a lumber milling question for you related to some large raised panel doors I'm building out of cherry for a floor to ceiling kitchen pantry. I don't have much experience with...

Hi Bill,

I appreciate your insights. I didn't mean to come across as overly sensitive and apologize to Pat and Jack again if that's the case. I was just surprised that my original question...

Hi Tim,

Thanks very much for your suggestions.

It's quite possible it is I who should apologize to you and Pat (and everybody else) if my reaction to Pats comment was overly sensitive. It...

Hi Darius,

That's interesting. Sounds like you're accidentally producing the result I'm aiming for but can't seem to achieve if my life depended on it. What you describe regarding clamping seems...

Hi Doug,

Thanks for the input. Maybe I need to dust off my jointer plane, sharpen it up and give it a workout. It might prove easier than trying to master the power jointer approach.

I have...

Hello Pat and Jack,

Thank you for your comments, but I'm not sure I understand where you are coming from regarding my question. It would seem you are criticising me for wanting to master what...

Hi Michael,

Thanks for the link. I just read Gary Ragowski's article and will try his method tomorrow. I think in my own way I tried something similar earlier today but probably not quite as...

Hi Folks,

Hopefully this is a fairly simple question (despite the length of my post...sorry!).

I'm gluing up several panels for some raised panel doors I'm building and I'm trying to use my...

Hello All,

I've just noticed an odd little problem I seem to be having when cross cutting on my table saw. I was trying to fine tune the alignment of my mitre gauge (Incra 5000 converted to a...

Hi everybody,

Thanks a lot for all the input. I really appreciate it!!

Sounds like I left out a few details I should have mentioned but I was trying (unsuccessfully) to be brief.


In any...

Hi everybody,

Thanks a lot for all the input. I really appreciate it!!

Sounds like I left out a few details I should have mentioned but I was trying (unsuccessfully) to be brief.

In any...

I have an almost brand new Steel City 3hp granite top saw (Model 35905G, I if recall correctly) that just doesn't seem to want to perform "up to snuff". My rip cuts are coming out either badly burned...

Hello Sawmill Creek,

I am finally getting around to building a custom router table cabinet for the Jessem Mast-R-Lift Excel router table top that I purchased several months ago. I’ve been reading...

Hello Sawmill Creek,

I am finally getting around to building a custom router table cabinet for the Jessem Mast-R-Lift Excel router table top that I purchased several months ago. I’ve been reading...