Search:

Planes have been sold.

Bump for the weekend

Bump for the weekend

Square is SOLD

I think the OP was referring to planing the protruding dovetails, which would be end grain. For that, try wetting the end grain with a bit of alcohol, or a 50/50 mix of alcohol and water, this will...

I have for sale a vintage Stanley #20 try square in the very useful 8 inch size with rosewood stock. It has been gently reconditioned into a good worker condition, including the edges of the beam...

I have for sale a Record 073 rabbet / shoulder plane in beautifully restored condition. This plane had surface rust when I got it about 20 years ago which I completely cleaned up. There is no...

I have for sale two Stanley block planes. They are made in England of relatively modern manufacture. The first is a G12-060, which has a 1 3/8” wide iron. The second is a G12-020 which has a 1 5/8”...

What’s the Location?

Item is sold.
-Sam

Scorp is sold pending payment

Paul, its available. Sent you a PM.
-Sam

I have for sale a German made chairmaker's scorp. It is labelled Bracht, which was a mark of tools sold by Leichtung, likely in the 70’s or 80’s. According to online research I can find (caveat...

Todd, I have this same saw and am curious if you found the Carter guides to be a significant improvement?

Sam

Warren, tell us more about the whys and wherefors of Dux seal. Is it to dampen vibration and add weight?

I concur completely. I received mine about 6 months ago and it is one of the most delightfully balanced tools I’ve ever had the pleasure of using.
Sam

Fastcap makes a tape measure with on edge blank so it can be marked on. They also make a flat version (not curled to stiffen the blade) so it makes it easier to align the edge of the tape to a...

You could also cut a stopped dado and a deep slot on the end of the top to receive the angle. The top would be slid in from the front and the angle is completely hidden. This will only work if the...

There really should be a definitive thread on this damn sharpening question to settle this once and for all! Oh wait, that’s been done about 19,000 times!

Personally, I use stones made from...

Rich, I’m curious why you are putting another separator inline since the supercell already has a cyclone separator?

Thank you Edward.
Other than not having the issue with rubber spalling, are there other benefits that you see?


If anyone has a recommendation for sourcing link belts, I’d be happy to hear it.
...

I have a Powermatic 90 with a Reeves drive. Wondering if anyone has any experience with putting a link belt on the reeves pulley and what the results were. Quieter? Smoother?

-Sam

I'd also like to hear opinions on KV and Accuride slides versus the big names like Hettich, Blum, Salice, Grass.

Thanks for the suggestions. I'm in no rush so will watch for deals and poke around for some used ones as well.

Sam

Has anyone identified a source for Easy Wood tools that discounts from MSRP?