My bench top is just over 4" of hard maple. I bought a tapering bit from LV and used it on all of my holes from the underside. I figure that I've tapered the bottom 1.5" on all of the holes. All I...
Type: Posts; User: Scott Rud; Keyword(s):
My bench top is just over 4" of hard maple. I bought a tapering bit from LV and used it on all of my holes from the underside. I figure that I've tapered the bottom 1.5" on all of the holes. All I...
Hi Mike - Are you using the micro bevel feature in that jig? I have the same jig and have found that when ever I use that feature, I'm out of square when I starting honing. I went to great lengths...
Keep in mind, if you decide to camber your iron in the bevel up jack, you'll need a lot of it to make it noticeable. The low (12 degree, if I recall correctly) makes adding camber to bevel up planes...
Have you used that jig with success before? I ask because it appears that you secondary bevel is not even across the blade. I had the same experience with that jig when using that knob to create...