Search:

Almost finished now:

http://www.woodworkingtalk.com/attachments/f9/273538d1485054947t-custom-scroll-saw-stand-anti-vibration-front.jpg

I want to find some plastic tubes to store the saw blades...

True. I still do regular pilot holes with one drill to get the depth right, then, with the countersink in the impact driver on full speed, bore/rout the counter sink cleanly.

I use DeWalt's brand from HDepot. I was thinking of buying an extra impact driver/drill just to use with a counter sink bit before I saw them. I got the 3 pack for $25 after trying out the single...

I'm working on a new stand for my Excalibur scroll saw. I used to keep it on a cheap Harbor Freight table, not bolted down, but with the rubber feet on. I couldn't really use the higher speed...

I upgraded the edge fence of my planer.



350517


The one that comes stock with it is pretty small and the bracket that thumb screws onto the side is a little thin for the slot. So I got a...

I recently got a Delta 36-6022 10" portable contractor table saw and want to upgrade the fence. The fence it comes with has a bit of play whenever I move it and I use a square to re-check it each...

That's funny, I tried the same thing. When I removed the back plate, there was a small piece of black foam between the plate and plastic body. I guess that's how they adjusted it. I tried some...

I have an older model Dewalt DW680 electric hand planer from a pawn shop. It's never worked with much precision. The old blades on it had a little nick in them from a nail or something. I would...

1:50 into it:

http://youtu.be/j6XY7v2Z-9s

Doug Thompson on sharpening:

http://youtu.be/ttYyulsM7wg

I've watched those videos dozens of times, lol. Maybe I'll work on some videos to share when I get back to my shop next week. I was trying to use it in "bevel rubbing mode" at a 45 degree angle,...

I got the Hercules, but am having a hard time trying to finish cut with it without getting mini-cove type of cuts since it's a round cutter. Know what I mean? Not sure how to correct it. Sometimes...

I use two cinder blocks with big Irwin clamps. I wedge the wood between the blocks and clamp 'em tight around the piece and stand on them when I cut or drill big holes. Pretty good makeshift vice...

Hmm. Yeah, the grain goes all sorts of ways. I mostly want to get the rough cut tool marks off and hopefully sand above 100 grit after that. What carbide cutters would you recommend? I was...

Thanks for all the different info. I included some pictures. The first 2 were done with a skew. I think going down hill in opposite directions causes different effects with the tung oil I used. ...

I have a bunch of bowling pins that I hollow out and turn into birdhouses. I was wondering if it's possible to get a skew-like surface on the entirety of the outside with a tool to eliminate most of...