Search:

Mike, I had a similar dilemma to yours. I do custom building, and was looking for someone to do some engraving. The local jewelry store had the equipment, and did a very nice job, but it cost me...

So, did you end up with the laser? It went for more than I thought it was going to.....

Right now, if you're "in" it's $575.00. If you're bidding, then it's going to cost you at least $600.00. My bet is the last 2 minutes will tell you more! Good luck!

I have actually been wondering the same thing. I have some scrap pieces of 1/8" UHMW coming for a trial run. I will let you know how it goes.

I tried a search, but didn't come up with it. Any help with finding that thread and file would be great!

Thanks folks! That's exactly what I was looking for...

I am looking for a source for some nice items that I can laser-engrave a logo on, and have them passed out at a convention.

when I got my laser, I got some real nice key-chains, with a hardwood...

At the power/speed you can engrave leather at may make it tough to go through the mask, unless it is very thin.

When I first started experimenting with the mask, I didn't have tape wide enough to...

Dan, in the sake of experimentation, the material I was testing was 416F stainless. It is what all of my barrels are made of. Much easier to machine than the more corrosion resistant 300 series of...

The paint lies far enough below the surface that it doesn't get worn or scratched. The first stock I had done this way, a couple of years ago, long before I was doing the engraving myself, is still...

I am real new to this, so I have not ventured very far, or had time to do so, but here is what I have been using that process on.

Here is a picture of a stock that has been masked-off, and...

Dan, you can theorize all you want, but it IS engraved into the metal. I have held the part in my hand, and have inspected it carefully under magnification, trust me, the marking is not laying on the...

My company name and trademark was reduced way down from a large file for other use. I tried the same file, and the same ratio on other material and got the same results. The ".223 Remington" script...

I have been following this thread with great interest. I am a custom gun builder, and have been looking, for YEARS for a good way to mark on stainless barrels. I have purchased special stamp-sets,...

I'm a real newbie here, and to laser engraving, but I am doing a process that may work on leather.

I am engraving black plastic that I want to highlight with color. What I am doing is taking...

Newbie here! I've seen a couple of attachments on a couple of different threads like this one that ends in .cdr

I can't seem to open view it. All I get is a screen full of letters.... ...