I seen detailed instructions here:
http://www.hand-cut-dovetails.com/tools/8chisEgs/edges.html
I have no affiliation with the site, just passing the link.
Type: Posts; User: Tim Leo; Keyword(s):
I seen detailed instructions here:
http://www.hand-cut-dovetails.com/tools/8chisEgs/edges.html
I have no affiliation with the site, just passing the link.
Maybe you could shorten the saw a couple of inches to avoid the cracked area?
LIGHTLY joint the saw and try shaping the teeth again. Sometimes it takes more than one pass to get it right.
A 4/4 board is 1-inch thick before it is surfaced. The 4/4 boards I buy at the lumberyard that are surfaced on 2 sides are only 3/4-inch thick. Bringing that down to 1/2 inch thick means removing...
I enjoyed that very much. Thanks for sharing. How, exactly, did you hang it on the wall? The shiplap panel on the back doesn't lend itself to screwing through the back of the cabinet to attach it...
Why is everyone cutting the cover?
Try this article:
http://www.wkfinetools.com/contrib/jThompson/restore/perfHandle/perfHandles1.asp
I've got a 110 that I use all the time. Clean them up and put them to use!
I've had that problem with ebay also. Suddenly things are coming to the house that I don't need.
Maybe not. That one is for selling so you can buy even more user tools. If Clint is offering, I'd be selling.
I have a Norse Woodsmith saw. I think it is harder [to not warp or bend the saw] than you imagine.
Can you start the cut in the middle of the board and work to the end?
I have the LN 60-1/2R rabbet block and I can tell you from first hand experience that is an outstanding plane. I use it to clean up rabbits, trim tennons to size, and general block plane useage. I...
LN Handtool event? Where? When?
yikes, that's kinda short notice. Who showed up?
I have set of Witherby paring chisels (with flat sides) that I use with a mallet, a set of Swan bevel edge paring chisels that are for hand use only, and a set of Stanley Defiance bench chisels for...
How much of a taper will the top of the vise jaw have if the vise is not tightened fully? And if you decide you dont like the taper, you can always tighten the vise, plane again, and remove the...
I have a maroon (purple?) 60-1/2 that works great. It did need a fair amount of fettle to get the bottom flat and get the blade to register in the advancing mechanism, but in the end it is a great...
Can you post a photo and point out the tabs?
I think I bought the #6's brother. It looked like the surface of the moon. I spent a couple of hours with a deburring wheel and some 60 grit sandpaper to clean it up. It's not beautiful, but it...
Could you expand on that a little? How does sliding the bar down change the width of the tail? I don't get it...:confused: It looks like the tapered part of the brass aligns with the wood flat...
If your not sure if they need to be replaced, send them to me and I'll inspect them for you.
Wow. I never saw a left-handed bench before. Cool.
You don't have to 'make' the iron. Buy a flat soled wooden plane from the *bay and modify it. I took a skew iron plane and cut the sole to the angle I wanted and then ground and sharpened the blade...
How long did it take until the kids left the shop?