Hi John,
I mostly understand what you are explaining. I will try the setup and I may be able to figure it out. I have 3 net frames already out of the forms and I am at a stand still until I figure...
Type: Posts; User: Phil Watson; Keyword(s):
Hi John,
I mostly understand what you are explaining. I will try the setup and I may be able to figure it out. I have 3 net frames already out of the forms and I am at a stand still until I figure...
Thanks for the suggestions, Wayne's idea will work for cutting the groove centered in the wooden 3/4 inch wide net frame hoop not the net material. The groove is for the 50 lb tensil strength thread...
I need to make a 1/16 inch deep groove 3/32" wide on a fishing landing net. I am thinking of using a slot cutter, the guide bearings I have are to small, I need a 8mm X 46mm x 6mm a google search did...
I have the caster set from Woodmaster on my 2675, rolls beautifully.
I have the Woodmaster 2675 now for about a year, have changed the sand paper many times going from grit to grit and I have not had any problems in doing so. I have measured side to side measurements...
Also a round over on ceramic and porcelain tile is a bull nose.
Thanks for the suggestions. I will look to see if there is a manufactures name on it and call for their recommended cleaning instructions.
I have been using my dust collection system for a few years now and have been blowing air through the pleats to clean the dust. After inspecting the interior of the filter it is very dusty and the...
Thanks for the replys. Yes my wood is going to be 4/4 it is still in the form of logs which have been cut 2 weeks ago. I am waiting for the snow to melt as that is when the woodmizer opperator will...
I have approximently 1,500 board feet feet of red oak lumber that I want to have kiln dried. I have been unable to locate a kiln for hire here in northern Michigan. Does any one know where I can get...
I am not sure if this is the correct forum to ask this but here goes. I have a Jet floor model drill press that has a broken handle crank, this is the crank that raises and lowers the table. This...
Thanks Steve & John, I think I will give more consideration to Sutherland Wells Tung oil and sealer. I am putting it on a Morris chair and ottoman.
Phil
I have tried 6 different finishes with results I am not happy with on quarter sawn white oak. My wood
has a lot of flecking and rays. What I am looking for is something that will pop the rays and...
Count me in!
Phil
Please count me in
Phil
Please count me in.
Phil
please count me in!
Thanks,
Phil
These are the ones I made for Christmas presents. The plan came from a back issue of WoodSmith. They are an Arts and Craft style. The trunk is made up of 4 pieces 1 inch square.
Phil
142396
Please count me in.
Thanks,
Phil
Thanks for the suggestions. I will give it a go tinite.
Phil
Hello SMC, I have been a long time contributor and reader of the forum and have gained alot of knowledge over the years. I have question on how to level the legs on my newly assembeled coat tree, it...
Please count me in.
Thanks,
Phil
I also would like to know the location of the saw mill in Gladwin.
Thanks,
Phil
I want in.
thanks, Phil
count me in