I just ordered both the bracket & cone. Hopefully I will have some good luck paying through Amazon pay. I have been wanting to upgrade my Jet since finding it on Craigslist for $100.00 a few years...
Type: Posts; User: Ron Dorsch; Keyword(s):
I just ordered both the bracket & cone. Hopefully I will have some good luck paying through Amazon pay. I have been wanting to upgrade my Jet since finding it on Craigslist for $100.00 a few years...
Jim,
See the attached photos of the combination planer & router table station I built. The planer is housed inside & under the router table box & has wheels at the corners to allow me to position...
It's a matter of separation. An accessory building needs to be a min. of 10'-0" from an adjacent structure on the same property & set per setbacks to a property line. The setbacks & separation from...
It's a matter of separation. An accessory building needs to be a min. of 10'-0" from an adjacent structure on the same property & set per setbacks to a property line. The setbacks & separation from...
Check out the combination planer -router station on my page. I have the height high and it works out fine for me. I'm 6' so I do not mind the height. I do not need to bend over to send a board...
Check out my gallery, I built a dedicated router table w/ fence that I slip over the table saw fence for a tall dable saw fence w/ the buit-in dust control. This design could be used for your need...
I bought my current dado set from HF sold under the name Avenger. It appears to be the same as the Olshun set. I have had it for 3 years now. Cuts a great dado but the copper shims tend to wind...
I use an old trestle style drafting table, It adjusts to just over the height of my TS & as low as 28". I tilts too. The pencil tray serves to hold pencils & other small tools as well. Size is...
I've noticed that there are times when there are Creekers asking for suggestions for Drill Press tables & router tables.
I thought I would add to the mix w/ two projects I put together.
The...
Add resilient 1/2" "z" furring chanels between any sheets of gyp board at 24" o/c. Make sure the sheets are of a different thickness, 1/2" & 5/8". Put the resilient channel to the sound side. Ad...
Mike,
I purchased the same jointer, it is my first. I found the fit and finish to be great. One problen I had was a dented motor fan shroud. First time I started it up It had a loud scraping...
If there is a Blaine's Farm & Fleet in your area they offer a 17" DP which is made by the same company that makes SC. Quality is right up there but it has a 4-7/8" quil travel. Runout is...