Search:

suggestions on procedure to refinish 12 year old dining table that was finished using polyurethane

I got the vacuum adapter thru robust this morning. They don't handle the vacuum hub, so I will make one, but thanks to everyone for offering their suggestions!!!!!!
Dean

Thanks to everyone who sent great suggestions.I will call Brent tomorrow, he just lives a couple of miles from me. I didn't know Robust was handling anything to do with vacuum chucking.
I don't...

I always use kiln dried wood and have never used air dried. I purchased a length of wood on the internet and lo and behold it is air dried wrapped in wax. My question is, when and what is the best...

I have a Powermatic 3520B and am trying to get vacuum system for it. I already have a Gast vacuum pump which I use for my vacuum bag for veneer. I need the vacuum adapter and the vacuum chuck I...

what is the best, easiest to set up and use vacuum chucks system? I have a Thomas continous run vacuum pump. I want do do small things, boxes, eggs, small bowls and spheres

Will Titebond glue stick to Polypropylene sheets. I'm looking for a product where I glue wood using titebond and the over run of the glue can be cleaned up like you can when using silicone. I...

I'm trying to do my first attempt at lamination then turn them. Any suggestions to get off on the right foot???

I need to cut 4 triangles, each 4" high, 3" long and have an angle of 15 degrees. I have a table saw and a bandsaw. Any suggestion to cut these so the four are the same and also to do it safely.

Bernie I don't have your E-mail address but my E-mail is papaofjej@charter.net, if you would send me the info you have, I would appreciate it very much. Thanks Dean

I am very interested in this type of turning but it is like hitting a brick wall. Two articles the the AAW magazine and a utube video by Alex Amoruso. In his video he shows a sled without...

Does anybody use boiled linseed oil as a finish???

Please give give me your opinion as to using as a finish. I have never used it but I heard that it leaves great results.



do you layer...

Good Lick!!!!! both my bearings were frozen inside the bearing blocks had to get one removed at a machine shop (thats the one that the without clip0. the other it was decided not to try to get it...

First of THANKS for the hints suggesrion and help, I really appreciate it. The new shelix is in!!!! I still have the table adjustments to do but I turned it on, nothing came loose sounds real good....

I have read several forums on how easy to change on a jointer, 1-2 hours.
I removed the head from the machine without any problem, removing the belt pulley took about 30 minutes with 20 minutes...