Search:

you'll have no problems with the cart moving, especially if you use the double locking castors. My shop is very small(9'x10') so I built a stand to incorporate my planer, os sander and morticer and...

Okay, so when I get my shop up and running and plumbed for air with the street Ls for the takeoffs and drops, with Ts, a filter on that connection(last one will be for my spray setup) which should be...

During my last project(kitchen table), I experimented with all types of different stains and finishes and tried spraying a few, for the 1st time. I noticed that I was getting a few water droplets in...

Hi Matt.
The Book advises to drain the tank daily and truth is that most of us try to but sometimes a couple of days or weeks slip by before it happens. I TRY to remember but am not always...

Hi Rajiv! I bought the LV Timbercheck metre that you're looking at and it works fine.It's a robustly built unit and comes with a spare set of pins, plus the battery(9V). You just have to remember...

Hi Dick. I have the GI mortiser and like it very much as it has about the best stock fence/ hold down going! It comes with 4 chisels that are of good quality. It does a great job of boring mortises!...

Dave, go with the Hook n Loop! I've had my 333 for close to 6 years now and have never had one moments grief! I can't comment on the variable speed issue but I use most of my tools equipped with VS...

Thanks Dick. Yes the lights will be on 3 separate circuits. The fluorescents will be on 2 and the 3 incandescent fixtures will be on another. I know it looks like a lot of outlets but they will be...

Von, that's what I'm planning on doing, so I can plug in my combination down draft/air cleaner/outfeed table. I'll have plenty of 120v and 240v outlets through out the shop. My 220v outlets will be...

Thanks guys! That's just what I thought, but I wanted to be sure. Neither website includes that information and I didn't want to be under wired as it's so much easier at this stage of the process! ...

I'm going through the process of drawing up plans for the new 22'x28' shop and am now figuring out electrical wiring placement and requirements. I've got tool placement and lighting figured out...