I realize this is an old thread but was wondering if anyone knows what the chuck mount thread size is for the H1214A ?
Type: Posts; User: gordon todd; Keyword(s):
I realize this is an old thread but was wondering if anyone knows what the chuck mount thread size is for the H1214A ?
Finally completed french drain/sump pump project. I enlarged the hole in the ground for the basin which enabled me to use a 22-1/2° elbow. That allowed me to drill with a standard hole saw. Now I...
Thanks to all for your replies. This is exactly what I needed: different methods to look at the same problem. I now think that I'll take a scrap piece of the pipe, cut it at an angle to match side of...
Thanks Bill, I need an Uncle George. Luckily my tolerences are not that critical. I'm working with plastic drum and pipe, so going slow with jigsaw should do it.
Thanks Jerry, that would probably be a more forgiving using jig saw.
Thanks Bruce, that's a good idea though i need to see if that will work on my drill press. Only problem I see is mounting guide block to curved surface without alot of fabrication. Maybe curve it...
I'm needing to drill 3-1/4" hole into side of 24" diameter plastic drum off center (not square to side of drum). I've put a longer pilot bit on but think a little less than half of teeth will be all...
The sites are indeed down, just got a great link from Brad on LJ : https://downforeveryoneorjustme.com you can use to confirm status of web sites.
Has anybody else experienced owwm.org and vintagemachinery.org sites being down?
The plate on mine is slightly bowed. I think that's from usage, not design. Probably could be thicker. maybe 3/16. The hole diameters are slightly larger than the rods but allow free movement.
Yes, just a plate with three holes. The two bottom corners are radiused.
Does anyone know what the paint color is? Looks a lot like Delta Tool gray.
431280431279Just started re-hab on mine that has been stored in my garage for the last 30 years.
plate: 1/8 x 1 1/2 x 5 3/4
pin: 1" long split pin