Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: The Super Structure MUST GO !

  1. #16
    Join Date
    Jan 2009
    Location
    Philadelphia, PA
    Posts
    246
    My shop will be in a 10x10 space with 7.5ft ceilings which are dropped below 7ft when the overhead door is up. I also cannot hang any lighting with this current arrangement. I plan to build swing out style carraige doors as what I have priced out thus far is simply too expensive. A google search reveals alot of good photos to get some ideas from. I'm not happy about dropping 200$ on an entry door rail and stile router bit set but its still cheaper than any quotes I have gotten thus far.

    Peter

  2. #17
    Do you have any room above the ceiling? I too did not want door rails killing my limited headroom so put the door through a slot in my ceiling between joists. I also didn't want the door to take up all the floor space of the storage above so ran the rails along the rafters.

Similar Threads

  1. Cutting Super Accurate Dados! I will pass on the Festool way...
    By Dev Emch in forum General Woodworking and Power Tools
    Replies: 15
    Last Post: 03-11-2006, 2:08 PM
  2. my version of Terry Hatfield's sheet goods storage structure
    By Frank Pellow in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 01-05-2005, 5:49 PM
  3. Freud Super Dado Prices HIKE YIKES!
    By Eric Porter in forum General Woodworking and Power Tools
    Replies: 12
    Last Post: 06-17-2004, 8:20 PM
  4. Rather ticked at Loctite Super Glue
    By David Rose in forum General Woodworking and Power Tools
    Replies: 3
    Last Post: 03-08-2004, 10:48 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •