At the end of a Morse Taper insert (drive center, buffing system, etc.) that goes into the drive spindle (head stock) or live center (tail stock) there is often a internally threaded section.
To use a draw bar, the first thing you need is a head stock or tail stock that has a through hole. You thread a threaded rod into the Morse Taper insert, pass it through the hole, and use a threaded handle or other such device to keep the insert tightly in the hole.
Last edited by Frank Townend; 03-30-2009 at 9:48 AM.
"Dance like nobody's watching; love like you've never been hurt. Sing like nobody's listening; live like it's heaven on earth."