Anyone know where to get these guys? Trying to make some holders for my 1/2" router bits...
IMG_1041.jpg
Thanks
Andy
Anyone know where to get these guys? Trying to make some holders for my 1/2" router bits...
IMG_1041.jpg
Thanks
Andy
Lee Valley.
I use rubber ones from McMaster-Carr. Had I not already made the drawers for my bits, I would have used some LV ones simply because the style I was looking at had a bottom to them. http://www.leevalley.com/wood/page.a...=1,46168,50736
But the rubber ones work fine for me and were cheap! Attachment 114120 I bought a bag of 1/2" and 1/4" ones. Jim.
Not sure why the picture isn't coming through. It will if you click on it.
Coolmeadow Setters...Exclusively Irish! When Irish Eyes are smiling....They're usually up to something!!
Home of Irish Setter Rescue of North Texas.
No, I'm not an electrician. Any information I share is purely what I would do myself. If in doubt, hire an electrician!
Member of the G0691 fan club!
At a minimum, I'm Pentatoxic...Most likely I'm a Pentaholic. There seems to be no known cure. Pentatonix, winners of The Sing Off, s3.
An alternative from Rockler:
http://www.rockler.com/product.cfm?page=6064
Dave Falkenstein aka Daviddubya
Cave Creek, AZ
Uhh...Why put grommets in at all? Just bore lots of shank-diameter holes in a block of wood. It's easier than what you're doing. It also that means you can pull a bit out with one hand, instead of holding the holder with one hand and pulling the bit with the other.