Hi,
I am building a built-in... I fabricated a plywood box based on a template, allowing for about 1/4" slop on each side. I created a face frame out of walnut, and made solid walnut doors.
The doors are anchored with no-mortise hinges (i know... wimp)
I am building drawers out of maple and have some walnut for facing... to go in the middle.
For the top, I was going to re-template and make a cut to fit (less 1/16" on each side ~1.25" thick walnut top. Made from 6/4 glue up with biscuit joinery.
Question and concerns... I had planned on anchoring it all over using pocket screws... as seen in the photos in the picasa album. Will this cause problems with expansion/contraction? Any recommendations for a more successful approach.
Lots of angles, views... so listed in external album. Same project as seen below.
http://picasaweb.google.com/zargnut/...eat=directlink