Results 1 to 2 of 2

Thread: Improved Holddowns for JFM-5

  1. 05-06-2009, 5:49 PM #1
    Robert foster
    Robert foster is offline [OP] Member
    Join Date
    Oct 2007
    Location
    Corning, IA
    Posts
    176

    Improved Holddowns for JFM-5

    One on the shortcomings on the JFM-5 is the hold down. There isn't any. I improved the holding of the workpiece by gluing sandpaper to the backboard and the vise jaw clamp but still had a little problem with the workpiece staying put when using larger mortiser bits. So I made an improvement. See Pix.

    Bob
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  3. 05-06-2009, 6:14 PM #2
    Anthony Anderson
    Anthony Anderson is offline Member
    Join Date
    Nov 2005
    Posts
    708
    Very nice Robert! Thank you for sharing. I will definitely use your improvement. Regards, Bill
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules